Cableveyor now has gradually been widely used, we usually have to make the appropriate selection and use of technical points, specific information in this regard understand how much the cable towline manufacturers to learn more about the next:
Some choose thick cable, tubing, pipe, water pipes, etc., and the outer diameter of the towline in width as a reference, and leave at least 10% of the width of the space. Cable towline high: choose built-in cable, tubing, pipe, pipe, etc. thickest a reference height, plus at least 10% of the height of the space as towline high. If the overlap by overlapping the actual height as a reference height.
Bending radius R: choose built-in cable, tubing, pipe, pipe, etc. as the maximum bending radius, and left more than 10% of the space. Place principle should leave 15% of the remaining space for built-in cable, tubing and other activities are free, in the radial direction of the towline does not produce tension. Large differences in diameter wire should be laid separately, weight distribution, can be separated sheet separately if necessary.
At high speed or high frequency operation, we should try to make the wires apart from each other on a level, do not make it over another, the more time the cable, pipe, tubing, and other recommended separators. The main use of cable chains and selection techniques is that these, I believe that through this message, we have a better understanding of this area, before we use and the choice of cable chain, be sure to learn more about the relevant information, the only way in order to select the desired product, so as to continuously improve our work efficiency.